11.28
Removing engine guard
11.29
Installing the engine guard
–
Remove screws
–
2
Take off cover
–
Check the fluid level.
Fluid level below container rim
»
If the fluid level does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
Brake fluid DOT 4 / DOT 5.1 (
V02721-10
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up the overflowed or spilled brake fluid immediately
with water.
–
Remove screws
–
Pull the engine guard forward out of the holders and remove it.
V02695-10
–
Slide the engine guard into holders
–
Position the engine guard. Mount and tighten screws
sides.
Guideline
Remaining screws,
chassis
V02695-11
SERVICE WORK ON THE CHASSIS 11
1
.
3
with membrane
.
4 mm (0.16 in)
p. 127)
1
on both sides.
1
at the rear.
M6
10 Nm (7.4 lbf ft)
2
on both
65