Table of Contents
Advertisement
12.2
Adjusting the basic position of the hand brake lever
12.3
Checking the brake discs
Warning
Danger of accidents Worn-out brake discs reduce the braking effect.
–
Make sure that worn-out brake discs are replaced immediately. (Your authorized GASGAS Motorcycles work-
shop will be glad to help.)
Info
The motorcycle has an additional 5-D sensor. The 5-D sensor
makes the ABS control dependent on the angle of inclination and
pitch. This can prevent locking and slipping of the wheels during
braking when the vehicle is inclined (riding in curves) within the
physical limitations.
–
Adjust the basic position of the hand brake lever to your hand size
by turning adjusting wheel
Info
Do not make any adjustments while riding.
Push the hand brake lever forward and turn the adjusting
wheel.
The range of adjustment is limited.
Only turn the adjusting screw by hand, and do not use force.
V02722-10
–
When adjusting the brake lever, maintain a minimum clearance to
other parts of the vehicle.
Guideline
Minimum clearance
–
Check the front and rear brake disc thickness at multiple points for
A
the dimension
Info
Wear will reduce the thickness of the brake disc at contact
surface
Brake discs - wear limit
front
400406-10
rear
»
If the brake disc thickness is less than the specified value.
–
Change the brake disc.
–
Check the front and rear brake discs for damage, cracking, and
deformation.
»
If the brake disc exhibits damage, cracking, or deformation:
–
Change the brake disc.
1
.
5 mm (0.2 in)
.
1
of the brake linings.
4.5 mm (0.177 in)
4.5 mm (0.177 in)
BRAKE SYSTEM 12
67
Advertisement
Table of Contents
