Table of Contents
Advertisement
–
Pull on the top section of the chain with the specified weight
Guideline
Weight of chain wear measure-
ment
–
Measure distance
Info
Chain wear is not always even, so you should repeat this
measurement at different chain positions.
Maximum distance
18 chain rollers at the longest
chain section
»
B
If distance
–
Change the drivetrain kit.
400987-10
–
Check the chain sliding guard for wear.
»
If the lower edge of the chain pins is in line with, or below, the
chain sliding guard:
–
Replace the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
»
If the chain sliding guard is loose:
–
Tighten screws on the chain sliding guard.
Guideline
Screw, chain
sliding guard
S02194-01
SERVICE WORK ON THE CHASSIS 11
15 kg (33 lb.)
B
of 18 chain rollers in the lower chain section.
272 mm (10.71 in)
B
from
is greater than the specified measurement:
Info
When a new chain is mounted, the rear sprocket
and engine sprocket should also be changed.
New chains wear out faster on an old, worn rear
sprocket or engine sprocket.
M6
10 Nm (7.4 lbf ft)
A
.
Loctite
®
243™
61
Advertisement
Table of Contents
