11.30
Removing the engine sprocket cover
11.31
Installing the engine sprocket cover
Main work
–
Remove screws with toothed washers
–
Remove end cap and outer tube
–
Remove glass fiber yarn filling
–
Clean the parts that need to be reinstalled and check for damage.
–
Mount the new glass fiber yarn filling on the inner tube.
–
Slide the outer tube over the glass fiber yarn filling.
–
Insert the end cap into the outer tube.
F02992-10
–
Mount and tighten the screws with the toothed washers.
Guideline
Remaining screws,
chassis
Finishing work
–
Install the main silencer. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Remove screws
–
2
Remove screw
–
Take off the engine sprocket cover.
F02993-10
Main work
–
Position the engine sprocket cover. Mount screws
tighten yet.
–
Mount and tighten screw
Guideline
Screw, engine sprocket
cover
–
Tighten screws
F02993-10
Guideline
Screw, engine sprocket
cover
Finishing work
–
Remove the motorcycle from the lift stand. (
SERVICE WORK ON THE CHASSIS 11
1
from the silencer cap
3
.
4
from the inner tube.
M6
10 Nm (7.4 lbf ft)
p. 52)
p. 37)
1
.
.
2
.
M8
15 Nm (11.1 lbf ft)
1
.
M6
10 Nm (7.4 lbf ft)
2
.
1
, but do not
p. 37)
53