–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal ring
spacer.
Long-life grease (
–
Insert a spacer.
V01510-10
–
Clean and grease the thread of the wheel spindle and nut
Long-life grease (
–
Clean and grease the wheel spindle.
Long-life grease (
–
Mount the damping rubber and rear sprocket carrier in the rear
wheel.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the chain on
the rear sprocket.
–
Mount wheel spindle
but do not tighten yet.
–
Make sure that chain adjusters
5
screws
.
Guideline
In order for the rear wheel to be correctly aligned, the markings
on the left and right chain adjusters must be in the same position
V00510-10
relative to reference markings
Info
Mount left and right chain adjusters
tion.
–
2
Tighten nut
Guideline
Nut, rear wheel spindle
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
Screw, wheel
speed sensor
1
and contact surface
p. 129)
p. 129)
p. 129)
3
4
and chain adjuster
4
are fitted correctly on adjusting
B
.
4
.
M25x1.5
90 Nm (66.4 lbf ft)
6
in the hole.
7
.
M6
6 Nm (4.4 lbf ft)
WHEELS, TIRES 13
A
of the
2
.
2
. Mount nut
,
in the same posi-
Loctite
®
243™
81