–
Remove screws
dlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
below.
–
Place the handlebar support in the required position.
Info
The handlebar supports are longer and higher on one side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
Guideline
Screw, handlebar
support
S02164-10
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamp.
–
Mount screws
Handlebar clamp marking
the handlebar scale.
W00175-10
–
First bolt the handlebar clamp with screws
higher side of the handlebar supports so that both parts touch.
–
Tighten screws
Guideline
Screw, handlebar
clamp
TUNING THE CHASSIS 10
1
. Take off the handlebar clamp. Remove the han-
2
. Remove handlebar support
4
and push through nuts
2
.
M10
45 Nm (33.2 lbf ft)
1
, but do not tighten yet.
A
is aligned with centre line
1
1
evenly.
M8
20 Nm (14.8 lbf ft)
3
.
5
from
Loctite
®
243™
B
of
onto the longer,
49