Safety Precautions - Thermo Scientific WAE 32-OSD Operating Instructions Manual

5. Safety precautions

Observe these safety precautions for your own safety!

The exclusive purpose of your WAE 32/60-OSD softening system is to soften drinking
water.

Do not start to install or operate the system until you have taken notice of the
appropriate information given in these operating instructions.

Two people are required to lift and carry the softening system (to the installation
location, for example). Take hold of it at the corner points under the base plate.

Please note that the manufacturer is not liable for damages resulting from a use other
than the intended purpose or improper operation.

The CE-Mark is invalidated when constructional changes are made to the system or
products from other manufacturers are installed in it.

Protect the system from frost. The temperature in the area in which the system is
installed must be at least +2° C and is not to exceed +40° C.

Observe all applicable general regulations and requirements that apply at the
installation area, including accident prevention regulations.

The raw water pressure must be at least 2 bar and not more than 6 bar. If the raw
water pressure is higher, install an additional pressure reducing valve.

Water purification systems must be equipped with a safety device acc. to DIN EN
1717 to protect the tap water line from contamination.

A 230V, 50Hz socket with a protective contact must be made available.

The installation area must have a free running floor-level drain of at least DN 50 (38.5
internal diameter). When such a drain is not available, we recommend that you install
a water watcher (article no. 16.0129), otherwise the manufacturer will not accept any
liability for damage caused by water.

Gravity flow to the waste water system is to be ensured.

Position the system so that operation of the voltage network separation device is not
impaired.

Ensure that there will be sufficient working room around the system for unproblematic
operation of it when selecting the installation area.

The warranty is valid for a period of 12 months.
8
Thermo Scientific Barnstead
Softening system WAE 32/60-OSD