Directives And Manufacturer's Declaration; Electromagnetic Environment - Otto Bock Genium X3 3B5-3 Instructions For Use Manual

Beep Vibration
signal signal
3x short 3x short
Battery charge level
During the charging process, the current battery charge level is indicated by the number of LEDs
lit on the side of the charger.
LEDs 0
Battery 0%-10%
charge level

16.3 Directives and manufacturer's declaration

16.3.1 Electromagnetic environment

This product is designed for operation in the following electromagnetic environments:
• Operation in a professional healthcare facility (e.g. hospital, etc.)
• Operation in areas of home healthcare (e.g. use at home, use outdoors)
Observe the safety notices in the section "Information on proximity to certain areas" (see
page 63).
Event
Maintenance note:
E.g.: Maintenance interval has been
exceeded, temporary disruption of a
sensor signal
1 2
10%-30% 30%-50%
Resolution
• Use the Cockpit app to check
the next maintenance date for
the prosthesis (see page 82). If
the date is within the next
month, make a maintenance
appointment with the O&P pro­
fessional. For this appointment,
the O&P professional has to be
provided with the battery char­
ger and power supply in addi­
tion to the prosthesis and tube
adapter.
• Conduct the self-test again by
connecting/disconnecting
battery charger.
• If the beep is emitted again and
the maintenance date has not
been reached or exceeded, you
should visit the O&P profes­
sional soon. If necessary, the
O&P professional will forward
the prosthesis to an authorised
Ottobock Service Center.
• The product can be used
without restrictions. However,
vibration signals may not be
generated.
3 4
50%-70% 70%-90%
the
5
>90%
99