Information On Proximity To Certain Areas - Otto Bock Genium X3 3B5-3 Instructions For Use Manual

4.6 Information on Proximity to Certain Areas

CAUTION
Insufficient distance to HF communication devices (e.g. mobile phones, Bluetooth
devices, WiFi devices)
Falling due to unexpected behaviour of the product caused by interference with internal data
communication.
Therefore, keeping a minimum distance of 30 cm to HF communication devices is recom­
►
mended.
CAUTION
Operating the product in very close proximity to other electronic devices
Falling due to unexpected behaviour of the product caused by interference with internal data
communication.
Do not operate the product in the immediate vicinity of other electronic devices.
►
Do not stack the product with other electronic devices during operation.
►
If simultaneous operation cannot be avoided, monitor the product and verify proper use in
►
the existing setup.
CAUTION
Proximity to sources of strong magnetic or electrical interference (e.g. theft prevention
systems, metal detectors)
Falling due to unexpected behaviour of the product caused by interference with internal data
communication.
Avoid remaining in the vicinity of visible or concealed theft prevention systems at the
►
entrance/exit of stores, metal detectors/body scanners for people (e.g. in airports) or other
sources of strong magnetic and electrical interference (e.g. high-voltage lines, transmitters,
transformer stations...).
If this cannot be avoided, make sure to at least have a safeguard when walking or standing
(e.g. a handrail or the support of another person).
When walking through theft prevention systems, body scanners or metal detectors, watch
►
for unexpected changes in the damping behaviour of the product.
In general, monitor the product for unexpected changes in the damping behaviour when
►
electronic or magnetic devices are in the immediate vicinity.
CAUTION
Entering a room or area with strong magnetic fields (e.g. magnetic resonance tomo­
graphs, MRT (MRI) equipment...)
> Falling due to unexpected restriction of the product's range of motion caused by metallic
objects adhering to the magnetised components.
> Irreparable damage to the product due to the effect of strong magnetic fields.
Take off the product before entering a room or area with strong magnetic fields and store the
►
product outside this room or area.
Damage to the product caused by exposure to strong magnetic fields cannot be repaired.
►
CAUTION
Remaining in areas outside the allowable temperature range
Falling due to malfunction or the breakage of load-bearing product components.
Avoid remaining in areas with temperatures outside of the permissible range (see page 90).
►
63