Ebm Setup; Checking The Ebm Accessories - Eaton Powerware BladeUPS User Manual

STANDARD SYSTEM INSTALLATION
Table 6. BladeUPS Bar Wiring Specifications
BladeUPS Bar
Terminal Block
Output
Input
Neutral
Safety Ground
2
* Use 13.3 mm (6 AWG) 90_C copper wire minimum.

EBM Setup

52
Eaton BladeUPS (12 kVA) User's Guide
Terminal BladeUPS Bar
Position Wire Function
1 [Output A] Phase 1 Out
2 [Output B] Phase 2 Out
3 [Output C] Phase 3 Out
4 [Input A] Phase 1 In
5 [Input B] Phase 2 In
6 [Input C] Phase 3 In
7
8
9
Ground
6. Replace the wireway top cover, if removed, and the wireway access cover.
7. If installing optional EBM(s), continue to the following section, "EBM Setup."
Otherwise, continue to "UPS Setup" on page 57.
The BladeUPS EBM comes with all hardware required for installation in a standard
EIA or JIS seismic rack-mount configuration with square and round mounting holes.
The rail assemblies adjust to mount in 48-cm (19-inch) racks with front to rear rail
distances from 61 to 76 cm (24 to 30 inches) deep.

Checking the EBM Accessories

Verify that the following items are included with the EBM:
S
EBM front cover
S
Mounting brackets and fasteners (if not already installed):
- (2) mounting brackets
- (4) 6-32 flat-head screws
S
Rails and fasteners:
- (2) sliding rail assemblies (left and right)
- (2) rear hold-down brackets
- (12) hex-head screws
- (4) U-shaped 10-32 clip nuts
S
EBM user's guide
NOTE Discard the EBM user's guide if you are installing the EBM with a new UPS at the same time. Use
the UPS user's guide to install both the UPS and the EBM.
S
164201649 Rev 6 www.eaton.com/powerqualtiy
Terminal Wire
Size Rating*
13.3 mm
177 mm
NOTE Wire gauge depends
on overcurrent protection
rating required (see Table 5
on page 47). Reference the
NEC, NFPA 70 for wire
Neutral
sizing.
Neutral
Neutral
2
Ground 2 mm (14 AWG) to
52 mm
Tightening
Torque
2
(6 AWG) to
2
(350 kcmil)
31.1 Nm (275 lb in)
6 Nm (50 lb in)
2
(1/O)