Table of Contents
Advertisement
3. Display and menus
3.1
Display, buttons, and LEDs
No.
Name
1
Navigation
2
Stop
2
Configuration
2 and 1 Programming
3
Display
4
Alarm LED
User manual 4189341354A EN
Function
Move the selector up and down on the screen.
To see the Event log, push the Up
hold.
Stops the genset if manual or auto mode is selected.
When you push the button in auto mode, the running mode also changes to manual mode.
To go to the Configuration menu, make sure the controller is in manual mode, and then push
and hold the Stop
button until you see the configuration screen.
Push the Start
button to select a parameter, and to save changes you have made.
To go back to manual mode, push and hold the Stop
To go to theProgramming menu , make sure the controller is in manual mode. Then push the
down
button and the Stop
programming screen. To go back to manual mode, push the down
button at the same time and hold.
To see the Event log, make sure the controller is in the Programming menu. Then push the Up
button and the Stop
screen. To go back to Programming mode, push the down
at the same time and hold.
Graphical
The LED is red when there is an active alarm.
button and the down
button at the same time and hold until you see the
button at the same time and hold until you see the programming
button at the same time and
button.
button and the Stop
button and the Stop
button
Page 17 of 72
Advertisement
Table of Contents
