Table of Contents
Advertisement
3. Display and menus
3.1
Display, buttons, and LEDs
No.
Name
1
Navigation
2
Stop
2
Configuration
2 and 1 Programming
3
Display
4
Alarm LED
5
Start
6
Mode selection
User manual 4189341340A EN
Function
Move the selector up and down on the screen.
To see the Event log, push the Up
hold.
Stops the genset if manual or auto mode is selected.
When you push the button in auto mode, the running mode also changes to manual mode.
To go to the Configuration menu, make sure the controller is in manual mode, and then push
and hold the Stop
button until you see the configuration screen. To go back to manual
mode, push and hold the Stop
Push the Start
button to select a parameter and to save the changes you have made.
To go to the Programming menu, make sure the controller is in manual mode. Then push the
down
button and the Stop
programming screen. To go back to manual mode, push the down
button at the same time and hold.
To see the Event log, make sure the controller is in the Programming menu. Then push the Up
button and the Stop
screen. To go back to the Programming menu, push the down
at the same time and hold.
Graphical
The LED is red when there is an active alarm.
Starts the genset when manual mode is selected.
Push to change the running mode.
button and the down
button.
button at the same time and hold until you see the
button at the same time and hold until you see the programming
button at the same time and
button and the Stop
button and the stop button
Page 17 of 76
Advertisement
Table of Contents
