Table of Contents
Advertisement
4. You will see this screen on the display:
PASSWORD
5. Enter the password:
a. Use the Up
and Down
b. Select a number with the Start
6. You can now configure the parameter.
7. To leave the configuration menu, push and hold the Stop/Config
8. Until the configuration is saved, you will see this screen:
3.5
Configurable parameters
3.5.1
Module
General (GENERAL)
Parameter
Profile name
Power on Mode
(POWER ON MODE)
Power On Lamp Test
(POWER ON LAMP
TEST)
Deep Sleep Mode
(DEEP SLEEP MODE)
Auto-Clear Warning
Alarm
(AUTO CLEAR
WARNINGS)
Language
(LANGUAGE
SUPPORT)
Display (DISPLAY)
Parameter
Contrast
(CONTRAST)
Power Save Mode
(POWER SAVE MODE)
User manual 4189341354A EN
buttons to change the number.
button.
Range
Profile 1
Manual
Auto
Enable
Disable
Enable
Disable
Enable
Disable
English
Chinese
Range
0 to 100 %
Enable
Disable
button.
Default
Profile 1
-
Not enabled
Not enabled
Not enabled
English
Default
80 %
Not enabled
Description
You can change the name of the profile.
The controller is in this running mode when you
power on the controller.
If this parameter is enabled, the LEDs glow red
for 2 seconds after a power reset.
If this parameter is enabled, the controller goes
into deep sleep mode when the controller is not
in use for an adjustable time.
If this parameter is enabled, the controller
automatically clears an active alarm, when you
have resolved the condition that activated the
alarm.
You can change the display language if the
controller supports multiple languages.
Description
Configure the display contrast with this
parameter.
If this parameter is enabled, the controller turns
off the LCD backlight after an adjustable time.
Page 20 of 72
Advertisement
Table of Contents
