Governor Cable - Club Car Cafe Express Maintenance And Service Manual

FUEL SYSTEM: GASOLINE VEHICLES

GOVERNOR CABLE

Governor Cable Removal
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery-Gasoline Vehicles on page 1-3.
3. At engine:
3.1. If equipped, remove air deflector from top of engine.
3.2. Disconnect "Z" fitting of governor cable (1) from throttle lever (2) (Figure 14-7, Page 14-8).
3.3. Unsnap governor cable (1) from throttle body bracket (3).
4. At transaxle:
4.1. Disconnect "Z" fitting of governor cable (1) from governor arm (4) (Figure 14-8, Page 14-10).
4.2. Loosen jam nuts at governor bracket (5) and remove cable (1) from vehicle.
Governor Cable Installation and Adjustment
1. At engine:
1.1. Snap governor cable (1) into throttle body bracket (3) (Figure 14-7, Page 14-8).
1.2. Connect "Z" fitting of governor cable (1) to throttle lever (2).
1.3. If equipped, install air deflector on top of engine.
2. At transaxle:
2.1. Slide bellows off threaded end of cable housing, separate jam nuts and place threaded end into governor
bracket (5) (Figure 14-8, Page 14-10).
2.2. Finger-tighten jam nuts.
2.3. Push bellows back onto threaded end of cable housing.
2.4. Connect "Z" fitting of governor cable (1) to governor arm (4).
3. Rotate governor arm (4) counterclockwise until it stops and hold in this position (Figure 14-9, Page 14-10).
4. Adjust jam nuts until throttle lever (2) is at "wide open throttle" (WOT) (Figure 14-7, Page 14-8). Then, tighten the
jam nuts to 36 in·lb (4.0 N·m).
5. Release governor arm (4) and loosen jam nut (6) on throttle stop screw (7) (Figure 14-9, Page 14-10).
6. Adjust gap between governor arm (4) and throttle stop screw (7) to 0.055 in. (±0.039) (1.4 mm (±1)) as shown.
7. Tighten stop screw jam nut (6) to 36 in·lb (4.0 N·m).
8. Check engine RPM adjustment. See Engine RPM Adjustment on page 14-13.
2018 Café Express Maintenance and Service Manual
Engine Control Linkages
Page 14-9
14