Ground Speed; Governor Cable - Club Car Onward 2018 Maintenance And Service Manual

FUEL SYSTEM – SUBARU EX40

GROUND SPEED

NOTE: If possible, the manufacturer recommends measuring ground speed when setting engine RPM.
This vehicle should reach the forward ground speed specified in Section 2 – Vehicle Specifications. See How to
Measure Ground Speed on page 21-10.

GOVERNOR CABLE

Governor Cable Removal
B = 2.87 in. ± 0.039 (72.9 mm ± 1)
3132
Figure 21-4 Governor Cable At Throttle Body and Power
Limiter Screw Gap Adjustment
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3. At engine:
3.1. If equipped, remove air deflector from top of engine.
3.2. Disconnect "Z" fitting of governor cable (1) from throttle lever (2) (Figure 21-4, Page 21-7).
3.3. Unsnap governor cable (1) from throttle body bracket (3).
4. At transaxle:
4.1. Disconnect "Z" fitting of governor cable (1) from governor arm (4) (Figure 21-5, Page 21-8).
4.2. Loosen jam nuts at governor bracket (5) and remove cable (1) from vehicle.
Governor Cable Installation and Adjustment
1. At engine:
1.1. Snap governor cable (1) into throttle body bracket (3) (Figure 21-4, Page 21-7).
1.2. Connect "Z" fitting of governor cable (1) to throttle lever (2).
1.3. If equipped, install air deflector on top of engine.
2. At transaxle:
2.1. Slide bellows off threaded end of cable housing, separate jam nuts and place threaded end into governor
bracket (5) (Figure 21-5, Page 21-8).
2.2. Finger-tighten jam nuts.
2.3. Push bellows back onto threaded end of cable housing.
3
1
2018 Onward Maintenance and Service Manual
Engine Control Linkages
Page 21-7
21