Quantum SNC 4000 User Manual page 90

If the Firmware State is anything but Ready, the information output by
CAUTION
this command will be unreliable.
fcShowDevs
The fcShowDevs command displays information about the devices that are accessible from each FC
interface. The display shows the LUN that the SNC 4000 has assigned to each device, the SCSI Channel
that the device is attached to, the actual SCSI ID and LUN of the device, the vendor, product, revision and
serial number of the device.
SNC4000 >fcShowDevs
Targets Visible to Hosts on FC 1:
LUN Chan Id
-----------------------------------------------------
0 0 0
1 1 6
2 1 1
22 2 2
fcShowNames
The fcShowNames command displays the node and port names (addresses) of the FCs.
Ctlr Id Indicates the Channel Number for the interface
PCI Addr The PCI address of the interface, showing bus, device id, and function number.
ISPType The type of FC Controller, ISP2310.
Node Name The FC node name for the SNC 4000.
Port Name The FC port name for the interface.
fcTxDisable [port]
The fcTxDisable command disables a FC port transmitter.
Parameter Value
Port 1
SNC4000 > fcTxDisable 1
value = 0 = 0x0
fcTxEnable [port]
The fcTxEnable command enables or re-enables a FC port transmitter
Parameter Value
Port 1
SNC4000 > fcTxEnable 1
value = 0 = 0x0
84
Lun Vendor Product
0 ADIC Scalar SNC
0 ADIC Scalar 100
0 IBM ULT3580-TD1
0 IBM ULT3580-TD1
Meaning
The SNC connection labeled FC1
Meaning
The SNC connection labeled FC1
Rev SN
413* 601526
100A ADIC_1_07032002002
22U0 6811088354
22U0 6811085725fcShowNames
Service Port Command Reference