Table of Contents
Advertisement
Table 7
Commands Listed Alphabetically by Function
Command or Command
Group
ghostIOShow
mapMultipathSet
mapMultipathShow
mapRemoveDevice
tPathShow
DHCP
dhcpClientShow
dhcpEnable
dhcpDisable
dhcpState
resolvParamShow
Diagnostics
Environmental Sensors
envMonShow
Ethernet Network
arptabShow
ethAddrGet
ethAddrSet
gateAddrGet
gateAddrSet
host "add"
host "delete"
host "list"
hostNameSet
icmpstatShow
ifShow
inetstatShow
ipstatShow
64
Description
Display the length of time that commands to FC
targets remain queued
Change the setting for mapping new targets
Display the current setting for mapping new targets
Remove a device from the persistent device map
Display the state of targets mapped for failover
Display data received from DHCP server
Enable DHCP
Display data received from DHCP server
Display state of DHCP
Display list of DNS servers
Diagnostic commands are located in
Command Reference
on page 135.
Display all environmental channel states
Display a list of known ARP entries
Display Ethernet Port address
Set Ethernet Port address
Display network gateway address
Set network gateway address
Add host table entries
Delete network host table entries
List network host table entries
Change SNC 4000's network name
Display statistics for ICMP
Display Ethernet Port parameters and status
Display all Internet protocol sockets
Display statistics for IP
Page
86
95
95
96
121
74
74
74
75
101
Diagnostic
76
71
78
78
85
85
88
88
89
89
90
90
91
92
Service Port Command Reference
Advertisement
Table of Contents
