Quantum SNC 4000 User Manual page 87

: RX LOS Implemented ----------- Yes
: TX Fault Implemented --------- Yes
: TX Disable Implemented ------- Yes
--------------------------------------------------------------
fcPortModeGet [port]
The fcPortModeGet command displays the mode for the specified FC port. The default port mode is
Public Target. See also the fcPortModeSet command.
Parameter Value
Port 1
After the command executes, the number displayed as a value indicates the port mode as follows:
Value Port Mode
1 Private Target
2 Private Initiator
3 Private Target and Initiator
17 Public Target
18 Public Initiator
19 Public Target and Initiator
The following example shows how the connection type is displayed when the FC port is specified and the
port mode is Private Target.
SNC4000 >fcPortModeGet 1
value = 1 = 0x1
You must issue the fcRestart command or reboot the SNC 4000 for
CAUTION
the new setting to take effect. See the fcRestart command for
further information.
fcPortModeSet [port],[mode]
The fcPortModeSet command sets the mode for the specified FC port. See also the fcPortModeGet
command.
The default port mode is Public Target. Consequently, if attached to a Fabric device the SNC 4000 will
register as a "Target" with the name server. If the port mode is "Private Target," the SNC 4000 does not
register with the name server and the Fabric device will not recognize the SNC 4000 as a Target.
The port must be in Initiator mode if you want the SNC 4000 to scan for target devices on the port. When
the port is in "Private Initiator" mode, the SNC 4000 only scans for devices on the local loop. If the port mode
is in "Public Initiator" mode, the SNC 4000 also scans for devices attached to a Fabric.
Parameter Value
Port 1
SNC 4000 User's Guide
Meaning
The SNC 4000 connection labeled FC1
Meaning
The SNC 4000 connection labeled FC1
81