Table of Contents
Advertisement
fcConnTypeGet [port]
The fcConnTypeGet command is used to display the current setting of a FC port's connection type. See
also the fcConnTypeSet command.
Parameter
port
connection type
The following example shows how the connection type is displayed when FC port 1 is specified and its
connection type is loop.
SNC4000 > fcConnTypeGet 1
value = 0 = 0x0
fcConnTypeSet [port],[connection]
The fcConnTypeSet command is used to set the type of connection for a FC port. See also the
fcConnTypeGet command.
Parameter
Port
Connection Type
The following example shows how to set the FC port connection type to point-to-point.
SNC4000 > fcConnTypeSet 1,1
value = 0 = 0x0
You must issue the fcRestart command or reboot the SNC 4000 for
CAUTION
the new setting to take effect. See the fcRestart command for
further information.
fcFibreSpeedGet [port]
The fcFibreSpeedGet command displays the requested speed of the FC port. The actual speed can be
viewed in the output of the fcShow command. The example below shows that the FC port has a maximum
speed of 1 Gb/sec.
SNC4000 > fcFibreSpeedGet 1
value = 1= 0x1
Parameter
Value
port
1
SNC 4000 User's Guide
Value
Meaning
1
The SNC 4000 Connection labeled FC1
0
Loop
1
Point-to-point
2
Loop preferred
Value
Meaning
1
The SNC 4000 Connection labeled FC1
0
Loop
1
Point-to-Point
2
Loop Preferred
Meaning
The SNC 4000Connection labeled FC1
79
Advertisement
Table of Contents
