Table of Contents
Advertisement
SNC4000 > envMonRangeShow
Air Inlet Temp (C):
Nominal: 5 to 45
Warning: 4 <= N < 5 or 45 < N <= 50
Alarm:
Air Outlet Temp (C):
Nominal: 5 to 50
Warning: 4 <= N < 5 or 50 < N <= 55
Alarm:
IO Processor Temp (C):
Nominal: 5 to 80
Warning: 4 <= N < 5 or 80 < N <= 108
Alarm:
Input Power: +5 Volts (V):
Nominal: 4.94 <= N <= 5.36
Warning: 4.84 <= N < 4.94 or 5.36 < N <= 5.46
Alarm:
Input Power: +12 Volts (V):
Nominal: 11.00 to 12.93
Warning: 10.75 <= N < 11.00 or 12.93 < N <= 13.18
Alarm:
Local Power: +2.5 Volts (V):
Nominal: 2.42 to 2.58
Warning: 2.36 <= N < 2.42 or 2.58 < N <= 2.62
Alarm:
Local Power: +3.3 Volts (V):
Nominal: 3.20 to 3.39
Warning: 3.13 <= N < 3.20 or 3.39 < N <= 3.46
Alarm:
Fan :
Nominal: 1;
value = 1 = 0x1
ethAddrGet
The ethAddrGet command displays the IP address of the SNC 4000, specified as 4 decimal numbers
separated by periods.
SNC4000 > ethAddrGet
IP Address set to 192.168.1.176
value = 0 = 0x0
ethAddrSet
The ethAddrSet command changes the IP address of the SNC 4000. An IP address is specified as 4
decimal numbers separated by periods.
SNC4000 > ethAddrSet "192.168.1.54"
Host Address set to 192.168.1.54 for Ethernet interface
value = 0 = 0x0
If a netmask is required, specify it after the IP address in "dotted decimal" form. For example:
SNC4000 > ethAddrSet "10.0.0.2","255.255.0.0"
Inet Mask set to ffff0000 for Ethernet interface
Write complete
Host Address set to 10.0.0.2 for Ethernet interface
value = 0 = 0x0
78
N < 4 or N > 50
N < 4 or N > 55
N < 4 or N > 108
N < 4.94 or N > 5.46
N < 10.75 or N > 13.18
N < 2.36 or N > 2.62
N < 3.13 or N > 3.46
Alarm: 0
Service Port Command Reference
Advertisement
Table of Contents
