Table of Contents
Advertisement
This section describes how to install and set up the SNC 4000, SCSI devices, and the Host Bus Adapter.
Installation is divided into four sections:
•
Unpacking and Inspecting
•
Pre-installation
•
Installation
•
Post-installation
Unpacking and Inspecting
Unpack the SNC from the carton. Check to make sure that the following items are included with your SNC
and that none of them are damaged:
•
One SFP
•
Product documentation and software CD-ROM
•
Two HD68/VHDCI SCSI cables
•
One LVD terminator
NOTE: Save the CD-ROM in a safe location for future reference.
Pre-Installation
It is important that the items in the steps below are verified before installation of the SNC begins. This
ensures a successful installation of the product.
Required Tools
RS-232 straight through cable
RJ-45 patch cable
SC/LC fibre cables
SNC 4000 User's Guide
Required Software
ADIC Management Console
server/client software
SNC firmware
Getting Started
Other Resources
IP information for the SNC
System with HyperTerminal
Server to run ADIC
Management Console
11
Advertisement
Table of Contents
