Quantum SNC 4000 User Manual page 88

Parameter Value
Mode 1
2
3
17
18
19
SNC4000 > fcPortModeSet 1
value = 0 = 0x0
You must issue the fcRestart command or reboot the SNC 4000 for
CAUTION
the new setting to take effect. See the fcRestart command for
further information.
fcRestart [port]
The fcRestart command restarts the specified FC port. You typically use this command to restart the port
after changing its configuration settings so that the changes take effect. Issuing this command is an
alternative to rebooting the SNC 4000 in order to make the configuration changes take effect.
This command interrupts traffic.
CAUTION
Parameter Value
Port 1
The following example shows the display when the FC port is specified.
SNC4000 > fcRestart 1
value = 0 = 0x0:
Restart of FC Channel 1 succeeded
In order to get the command prompt (e.g. SNC4000 >) to show after you have executed the fcRestart
command, you will need to press the Enter key.
fcShow [level]
The fcShow command displays the channel status for the FC interface.
Level Meaning
0 or sets the verbosity level to the display in the example below
<blank>
1 displays the information displayed below, and appends a break-out
for each channel that includes Node Type, Node Name, Port Name
and Port ID
82
Meaning
Private Target
Private Initiator
Private Target and Initiator
Public Target
Public Initiator
Public Target and Initiator
Meaning
The SNC 4000 connection labeled FC1
Service Port Command Reference