Table of Contents
Advertisement
Parameter
Value
Port
0
1
OS
"nt"
"aix"
"solaris"
"hp-ux"
"linux"
"netware"
"gateway"
"generic"
"unisys"
"adic snc"
"pv-132t-fc"
"autosense/nt"
You must reboot the SNC 4000 after executing this command for the
CAUTION
new setting to take effect.
setNettime [value]
The setNettime command enables or disables timeserver functionality.
Value
Meaning
0
Disables timeserver functionality
1
Enables timeserver functionality
SNC4000 > setNettime 1
Nettime 1 value = 0 = 0x0
setScsiAssign [devID], [channel], [id], [lun]
When you are using Firmware 4.40 on a Fibre Channel blade, this command is
Note
unavailable.
The setScsiAssign command assigns a target device to a SCSI channel [channel] with SCSI Target ID
[id] and Logical Unit Number of [lun].
The indicated channel must be configured to be running in target mode. The [id] and [lun] must be available
on that channel.
The targets command displays the devID as the Idx.
Note
The example below shows the device with devID of 64 assigned to ID 0, LUN 0 on SCSI Channel 2.
SNC4000 > setScsiAssign 64,2,0,0
108
Changes will apply to all FC
Connections
Changes will apply to the FC
Connection (Connection 1)
Service Port Command Reference
Advertisement
Table of Contents
