Quantum SNC 4000 User Manual page 138

vpsShow [hostIndex]
The vpsShow command displays information about hosts that have been registered with VPS or eVPS
based on the value of hostIndex.
You can enter vps as a shortcut for vpsShow -1.
Note
Hostindex Meaning
-1 Displays brief list of all known host connections
0 Full display of all known host connections, and if online displays a list
of all LUNs available to that connection
N (1-48) Display the full information for the host N only
The following command example shows VPS or eVPS information for the hosts that have been registered
by VPS or eVPS. Hosts that have the HRS (host registration service) running with periodic re-registration
are shown with a status of "Periodic." One of the hosts has more than one Fibre Channel connection to the
SNC.
SN60023 > vpsShow -1
VPS State: Active
Id World Wide Name St. Typ HexFlags Status Host Name Host Type Host
Connection
--- ----------------- --- --- -------- --------- ---------- --
001 200000e0.8b0057d8 000 001 00000000 Online LANDERS NT 4.0 SP5 ScsiPort6
[0:0:0](QLA2200)
002 200000e0.8b16014d 000 001 00000000 Periodic SUPERIOR NT 4.0 SP5
ScsiPort7 [0:0:0](QLA2200)
003 200000e0.8b160152 000 001 00000000 Offline SUPERIOR NT 4.0 SP5
ScsiPort7 [0:0:0](QLA2200)
value = 0 = 0x0
SN60023 >
vpsSparseAccessSet[hostindex],"LUN string",[Access]
The vpsSparseAccess command sets the access for the specified LUNs for the specified host connection
index. Same as vpsAccessSet except LUNs are entered as a string of characters separated by commas.
Existing hostindex values can be determined by looking at the "ID "column in the output of the vpsShow -
1 command.
Access Meaning
0 Disables access to the LUNs
1 enables access to the LUNs
When you enter this command, the settings are stored in memory but are not applied until you enter the
vpsAccessApply command. The following command example enables host access to the LUNs 1, 2, 3,
4, 6, 9, 22, 23 and 45 on host connection index 1.
SNC >vpsSparseAccessSet 1,"1,2,3,4,6,9,22,23,45,"1
value = 0 = 0x0
SNC >
132 Service Port Command Reference