Quantum SNC 4000 User Manual page 130

Name : Password
nancy : SyecycRz
fred : b9dczebQbd
martha : RQQdRedb9d
user : cScQRSQzzz
value = 0 = 0x0
userHelp
The userHelp command displays a list of the user commands.
SNC4000 > userHelp
userAdd "name","password" - Add user to user list
userDelete "name","password" - Delete user from user list
userList
See User's Guide for more information
value = 0 = 0x0
version
The SNC 4000 is an intelligent device and has software that controls all functions. The revision of that
operating software can be displayed with the version command. The first line displayed is the SNC 4000
firmware version. The lines that follow pertain to the operating system software version.
SNC4000 > version
ADIC Firmware-4
Version 0401.0701 Built Mar 2 2001, 10:55:47 on EDELWEISS by terryk
VxWorks (for Buckhorn - IBM PowerPC 405GP Rev. D) version 5.4.
Kernel: WIND version 2.5.
value = 26 = 0x1a
vpmFeatureEnable "licensekeystring"
CAUTION: When you are using Firmware 4.40 on a Fibre Channel blade, this command is unavailable.
The vpmFeatureEnable command enables the optional VPM feature. You enable the feature by entering
the unique license key.
SNC > vpmFeatureEnable "BVRXC-G79DN"
value = 0 = 0x0
SNC >
If the license key was factory-installed, you can enter the word "enable" rather than the actual license key.
SNC > vpmFeatureEnable "enable"
value = 0 = 0x0
VPM License is Valid
SNC >
If value = 1 = 0x1 message is displayed, it means the license is already installed and VPM is already
enabled.
If the value = -1 = 0xffffffff message is displayed, it means the license is not already installed
and you do need to enter the license key.
See also the licenseShow command.
124
- Display user list
Service Port Command Reference