Quantum SNC 4000 User Manual page 79

copyScsiAssign [source channel], [dest channel]
If you are using Firmware 4.40 on a Fibre Channel blade, this command is
Note
unavailable.
The copyScsiAssign command copies the SCSI assignments from a source channel to a destination
channel.
SNC4000 > copyScsiAssign 1,2
value = 0 = 0x0
csClearLogFile
The csClearLogFile command clears the contents of the event log.
SNC4000 > csClearLogFile
value = 0 = 0x0
date
The date command displays the system's date and the time.
The system may be set to read its local Real Time Clock (see the dateSetFromRTC command) or a remote
host. See the rdate "timeserver" command.
The local Real Time Clock can also be synchronized with a remote timeserver See the rtcSetCurrent
command.
SNC4000 > date
SNC4000 > THU JAN 25 20:32:49 2001
dateSetFromRTC
The dateSetFromRTC command sets the SNC 4000's RTC as the source of the date display. Use the
date command to display the date and time.
SNC4000 > dateSetFromRTC
value = 0 = 0x0
deleteScsiAssign [dev ID],[channel], [id],[lun]
When you are using Firmware 4.40 on a Fibre Channel blade, this command is
Note
unavailable.
The deleteScsiAssign command deletes assignments previously created.
Example 1, below, uses the output of Example 2, next page, to delete assignments from SCSI Channel 2.
Example 1:
SNC4000 > deleteScsiAssign 64,2,0,0
value = 0 = 0x0
SNC4000 > deleteScsiAssign 82,2,0,1
value = 0 = 0x0
SNC4000 > deleteScsiAssign 98,2,0,2
value = 0 = 0x0
SNC4000 > deleteScsiAssign 124,2,0,3
value = 0 = 0x0
SNC 4000 User's Guide 73