Table of Contents
Advertisement
Client subnet mask: 255.255.248.0
Client router solicitation address: 255.255.255.255
Client IP routers: 172.16.32.2
Client DNS name servers:
172.16.9.63
172.16.40.24
Domain Name : adic.com
DNS Addr
Client DNS name servers:
172.16.9.63
172.16.40.24
dhcpState
The dhcpState command displays the state of the DHCP server: enabled or disabled.
SNC4000 > dhcpState
diagBoot
This command is used only to transition the SNC 4000 from normal operation to the special diagnostic
mode.
After completing use of the diagnostic commands, use the
CAUTION
normalBoot command to restore your system to normal operation.
It copies the existing bootline to a file in the ffs:mt directory on the SNC 4000 and installs a new bootline
directing the SNC 4000 to boot using a special diagnostic startup script ffs:mt/diagnstk.rc. It renames the
persistent map file config/device.map as config/device.bak (a new file will be generated after
rebooting).Finally, diagBoot issues a reboot command to put the changes into effect.
diagHelp
The diagHelp command displays a list of the diagnostic commands.
SNC4000 > diagHelp
** Diagnostic commands: Available in Diagnostic Mode Only **
elTest
Test Ethernet port w/loop-back cable
fcSlotTest <portnum> Test specified Fibre Channel port w/loop-back cable
normalBoot
scsiChannelTest <x,y> Test specified SCSI Channels w/loop-back cable
See User's Guide for more information
value = 0 = 0x0
disableCC [option number]
Disable the command and control interface (LUN 0) using the disableCC command. Specify one of two
option parameters as follows.
Option
Value
Number
1
Hides the Command and Control interface and results in Inquiry data
returning "device not available" for LUN 0.
SNC 4000 User's Guide
: 172.16.9.63
Shutdown and restart in normal mode
75
Advertisement
Table of Contents
