Quantum SNC 4000 User Manual page 107

----------------------------------------------|--------
value = 0 = 0x0
SNC4000 > reserveShow 1
Idx Tdev
Port Name
----------------------------------------------|--------
0 0x8fda380 ADIC
1 0x9ffcf08 IBM
value = 0 = 0x0
reset
The reset command immediately initiates a reset cycle. Any pending data writes to the flash file system
will be lost. This operation is not typically used. The reboot command should be used to gracefully
shutdown and restart the SNC 4000.
SNC4000 > reset
restartScsi [channel]
The restartScsi command restarts the specified SCSI Channel without issuing a bus reset.
SNC4000 > restartScsi 1
value = 0 = 0x0
resolveParamShow
The resolveParamShow command displays a list of DNS servers. This command is used to determine the
IP addresses of named hosts and is used whenever DHCP is enabled.
SNC4000 > resolvParamShow
.rm
To remove a file, use the rm command and specify the file name in quotes:
SNC4000 > rm "file.ext"
route
The route utilities maintain a route file, nvfs:/mgmt/route, which is used at system startup to initialize
the network routing table. Each route entry is a single line of the format:
destination:gateway
where
destination is an IP address (for a subnet or host) or the name of a host that is described in the
hosts file.
gateway is an IP address or the name of a gateway to a host. The gateway must be a device
on the local subnet.
An IP address is a text string in standard IP Address format (i.e., 10.0.0.2). A host or gateway name must
be listed in the hosts file.
Here is an example of the contents of the route file.
socrates:bruno
10.0.0:bruno
SNC 4000 User's Guide
Vendor Product
SNC 4000
DNES-309170W
Rev | Reservation ITL
40b5 |
SA30 |
Host's
101