Drum - Changing The Oil - Fayat Group DYNAPAC CC234C Instruction Manual

Figure. Hydraulic tank
2. Hydraulic reservoir cap
3. Sight glass
1
Fig. Drum, vibration side
1. Drain plug
152
Check the hydraulic fluid level in the sight glass (3)
2
and top off as required. See under the heading 'Every
10 hours of operation' for more information.
Start the engine and check that the filter does not leak.
3

Drum - Changing the oil

Position the roller with the drain plug (1) straight down.
Place a receptacle that will hold at least 7 liters (7.5
qts) under the plug.
Remove the drain plug (1). Allow all the oil to drain out.
Drain on both drum halves while refilling only is
necessary to do on one of the drum sides. (joint oil
bath)
Deliver the drain oil to environmentally correct Deliver the drain oil to environmentally correct
handling. handling.
See under the heading 'Every 500 hours of operation'
for filling oil.
Change the oil in both front and rear drum.
4812159901_D.pdf
Maintenance - 2000h
2023-01-25