Alarm Descriptions; Driving; Operating The Roller - Fayat Group DYNAPAC CC234C Instruction Manual

Symbol Symbol Designation Designation
Warning lamp, hydraulic filter Warning lamp, hydraulic filter
Warning lamp, air filter Warning lamp, air filter
Warning lamp, battery charging Warning lamp, battery charging
Warning light, engine temperature Warning light, engine temperature
Warning lamp, hydraulic fluid Warning lamp, hydraulic fluid
temperature temperature
1
2
Fig. Control panel
1. Rpm switch
2. Parking brake
3. Forward/Reverse lever
2023-01-25

Alarm descriptions

Function Function
If the lamp comes on while the engine is running at full If the lamp comes on while the engine is running at full
speed, the hydraulic filter must be changed. speed, the hydraulic filter must be changed.
If the lamp comes on while the engine is running at full If the lamp comes on while the engine is running at full
speed, the air filter must be cleaned or replaced. speed, the air filter must be cleaned or replaced.
If the lamp comes on while the engine is running, the If the lamp comes on while the engine is running, the
alternator is not charging. alternator is not charging.
Stop the engine and locate the fault. Stop the engine and locate the fault.
If the lamp comes on, the engine is too hot. Stop the If the lamp comes on, the engine is too hot. Stop the
engine immediately and locate the fault. engine immediately and locate the fault.
Refer also to the engine manual. Refer also to the engine manual.
If the lamp comes on, the hydraulic fluid is too hot. If the lamp comes on, the hydraulic fluid is too hot.
Do not drive the roller. Cool the fluid by allowing the engine Do not drive the roller. Cool the fluid by allowing the engine
to idle and locate the fault. to idle and locate the fault.

Driving

Operating the roller

Under no circumstances is the machine to be Under no circumstances is the machine to be
3
operated from the ground. The operator must be operated from the ground. The operator must be
seated inside the machine during all operation. seated inside the machine during all operation.
Activate working speed (1) = HI or ECO if available.
In ECO, the machine automatically regulates the
engine speed according to requirements.
If the machine is only to be transported, MID or ECO
should be selected instead.
Check that the steering is working correctly by turning
the steering wheel once to the right and once to the
left while the roller is stationary.
4812159901_D.pdf
Operation
71