Table of Contents
Advertisement
Fig. Drum, vibration side
1. Filler plug
2. Sight glass
Figure. Rear frame front left side
1. Hydraulic reservoir cap
130
Drum - oil level
Inspection - filling
Position the roller with the filler plug (1) at the highest
1
point in its rotation.
Wipe clean around the sight glass (2).
Make sure that the oil level reaches half way in the
sight glass. Top off with fresh oil if the level is low. Use
oil as specified in the lubricants specification.
Inspection and refilling is only necessary to make on
one side of the drum.
2
When removing the filler plug, wipe any metal
accumulated on the plug magnet off.
Refit the plugs and check that they are tight by driving
the roller and then rechecking.
Inspect both front and rear drum.
Hydraulic reservoir cap - Check
Turn up the machine so that the tank cap is accessible
from the left side of the machine.
Unscrew and make sure that the reservoir cap is not
clogged. Air must have unobstructed passage through
the cap in both directions.
1
If passage in either direction is blocked, clean the filter
with a little diesel oil and blow through with
compressed air until the block is removed, or replace
the cap with a new one.
4812159901_D.pdf
Maintenance measures - 500 h
Wear protective goggles when working with
Wear protective goggles when working with
compressed air.
compressed air.
2023-01-25
Advertisement
Table of Contents
