2
2
Figure. Scraper setting
1. Retaining unit
2. Adjusting screw
3. Lock nut
2023-01-25
Scrapers
Setting - Adjustment
Release the retaining unit (1) for the scraper bracket
and unscrew the adjusting screw (2) to release.
Push in the scraper bracket and tighten.
Adjust the screw (2) so that the scraper blade lies
approx. 2 mm (0.08 in) from the drum on the same
side as the screw.
Adjust the scraper bracket in or out on the other side
1
so that there is an equal gap between the scraper
blade and drum, and tighten the retaining unit (1).
3
The adjusting screw (2) is adjusted until the scraper
blade has a gap of approx. 1 mm (0.04 in) to the roller,
or lies loosely on the roller, along its entire length.
Tighten the lock nut (3).
4812159901_D.pdf
Maintenance, 10h
1-2 mm
(0.04-0.08 in)
113