Overview - Editing The Reading Display - TESTO 400 Short Instructions

Overview – editing the reading display
8.3
( )
Menu
Edit view
Zero pressure sensor
Adjusting Degree of Emission
8 Using the product
Description
The display can be edited for each
connected probe. The available
measurement parameters can be
selected and deselected and the unit
for each parameter can be adjusted.
These changes are saved for the next
measurement.
Once the testo 400 has been brought
into the operating position for a
differential pressure measurement,
the sensor should be zeroed against
ambient air.
If the testo 805i is connected, the
selection of emissivity appears here.
This can be set individually depending
on the measuring surface.
13