Inch Drive Backplane (Signal); X 2.5'' Front Drives - Lenovo ThinkSystem SR635 V3 User Manual

2.5-inch drive backplane (signal)

Use the section to understand the cable routing for signal cable connections for 2.5-inch drive backplanes.
Notes: For the server with a performance heat sink (T-shape), remove the heat sink before disconnecting or
connecting the cables which connect to PCIe 1, PCIe 2, PCIe 3, PCIe 4, PCIe 5, or PCIe 6 connectors (see
the table below). After disconnecting or connecting the cables, install the heat sink back to the server. See
"Remove a heat sink" on page 148
Your server supports the following server models with:
• "10 x 2.5 AnyBay backplane" on page 262

4 x 2.5'' front drives

Use the section to understand the cable routing for signal cable connections for 4 x 2.5'' front drive
backplanes.
4 x 2.5'' SAS/SATA backplane
Use this section to understand the SAS/SATA backplane cable routing for server model with four 2.5-inch
front drives.
• For the locations of connectors on the processor board, refer to
page 33.
and "Install a heat sink" on page
•
•
•
•
•
•
151.
1 PCIe 1 Connector
2 PCIe 2 Connector
3 PCIe 3 Connector
4 PCIe 4 Connector
5 PCIe 5 Connector
6 PCIe 6 Connector
"System-board-assembly connectors" on
Chapter 6
.
Internal cable routing
247