Lenovo ThinkSystem SR635 V3 User Manual page 111

Figure 58. Drive filler removal
Step 3. Install the drive in the drive bay.
Figure 59. Hot-swap drive installation
a. Ensure that the drive tray handle is in the open position. Slide the drive into the drive bay
until it snaps into position.
b. Close the drive tray handle to lock the drive in place.
Step 4. Check the drive LEDs to verify that the drive is operating normally. For details, see
page 293.
Step 5. Continue to install additional hot-swap drives if necessary.
After you finish
1. Reinstall the security bezel if you have removed it. See
2. Use the Lenovo XClarity Provisioning Manager to configure the RAID if necessary. For more information,
see
"Install the security bezel" on page
.
Chapter 5 Hardware replacement procedures
"Drive LEDs" on
184.
101