If you are instructed to return the old RAID flash power module, follow all packaging instructions and use any
packaging materials that are provided.
OCP module replacement
Use this information to remove and install the OCP module.
Notes:
• The OCP module is available only on some models.
• If ThinkSystem Redundant System Management Port Adapter is installed on the server, it will not be
displayed on the PCIe card list of system management software, such as XCC, LXPM, and so on.
Remove the OCP module
Use this information to remove the OCP module.
About this task
Attention:
• Read
"Installation Guidelines" on page 45
work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
DrpxDWLMfgtXO4O6BVYTim
Procedure
Figure 85. OCP module removal
Step 1.
Loosen the thumbscrew that secures the adapter.
Step 2.
Pull out the OCP module by its handle on the left as shown.
ThinkSystem SR635 V3 User Guide
138
and
"Safety inspection checklist" on page 46
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
to ensure that you