Procedure
Step 1.
Remove the top cover. See
Step 2.
Disconnect the cable of the RAID flash power module.
Step 3.
Remove the RAID flash power module on the chassis.
Figure 105. Removal of the RAID flash power module on the chassis
a.
Open the retention clip on the holder of the RAID flash power module.
b.
Take the RAID flash power module out of the holder.
Step 4.
Remove the RAID flash power module holder as shown if necessary.
Figure 106. RAID flash power module holder removal
After you finish
If you are instructed to return the old RAID flash power module, follow all packaging instructions and use any
packaging materials that are provided.
Install the RAID flash power module on the chassis
Use this information to install the RAID flash power module on the chassis.
About this task
"Remove the top cover" on page
212.
.
Chapter 5
Hardware replacement procedures
161