1.
Install the LACM into the two clips on the PSU air baffle. Ensure that the module is secured
in place.
2.
After the module is secured, route the cable through the cable clips to keep tidy for later
cable routing arrangements.
Note: For liquid detection sensor module working status, see
page
313.
Step 8.
Connect the pump cable and leak detection cable of the LACM to the connectors on the system
board assembly. See
After you finish
1. Install the backplane and the backplane cables if you removed them before. See
inch drive backplane" on page 61
2. Complete the parts replacement. See
Memory module replacement
Use the following procedures to remove and install a memory module.
ThinkSystem SR635 V3 User Guide
124
"Liquid assisted cooling module cable routing" on page
and
"Power/Sideband cable routing" on page
"Complete the parts replacement" on page
"Liquid detection sensor LED" on
242.
"Install the front 2.5-
244.
215.