Microsd Card Replacement; Remove The Microsd Card - Lenovo ThinkSystem SR635 V3 User Manual

a. Connect the M.2 cable to the backplane.
b. Tighten the captive screw to secure the M.2 cable to the adapter.
After you finish
1. Complete the parts replacement. See
2. Use the Lenovo XClarity Provisioning Manager to configure the RAID. For more information, see:
https://sysmgt.lenovofiles.com/help/topic/lxpm_frontend/lxpm_product_page.html

MicroSD card replacement

Follow the instructions in this section to remove and install the MicroSD card.

Remove the MicroSD card

Follow the instructions in this section to remove the MicroSD card.
About this task
Attention:
• Read "Installation Guidelines" on page 45
work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Make preparations for this task.
a. If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the
top cover, or remove the server from the rack. See
b. Remove the top cover. See
c. If your server comes with a rear drive assembly, remove it first. See
drive assembly" on page
d. If your server comes with a 7mm rear drive assembly, remove it first. See
rear drive assembly" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 46
"Remove the top cover" on page
169.
174.
215.
"Remove the server from rack" on page
212.
"Remove the 2.5-inch rear
"Remove the 7mm
.
Chapter 5 Hardware replacement procedures
to ensure that you
91.
135