Remove The Integrated Diagnostics Panel; Assembly - Lenovo ThinkSystem SR635 V3 User Manual

a. Insert the front I/O module into the front chassis.
b. Install the screws to secure the front I/O module in place.
After you finish
1. Connect the front I/O cables to the system board. See
2. Complete the parts replacement. See
Remove the Integrated Diagnostics Panel assembly
Use this information to remove the Integrated Diagnostics Panel assembly.
About this task
Attention:
• Read "Installation Guidelines" on page 45
work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Watch the procedure
A video of this procedure is available at YouTube:
DrpxDWLMfgtXO4O6BVYTim
Procedure
Step 1. Remove the top cover. See
Step 2. If the security bezel is installed, remove it. See
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 46
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
.
"Remove the top cover" on page
"Front I/O module cable routing" on page
212.
"Remove the security bezel" on page
.
Chapter 5 Hardware replacement procedures
224.
215.
to ensure that you
183.
81