Connect To Power - HMS Networks Anybus Communicator User Manual

® ™
Anybus Communicator - EtherNet/IP to EtherCAT MDevice

6.5. Connect to Power

CAUTION
Ensure that the power supply is turned off before connecting it to the equipment.
IMPORTANT
Using the wrong type of power supply can damage the equipment. Ensure that the power supply is
connected properly and of the recommended type.
Figure 11. Connect to power
1. Insert the cable wires to the terminal block and tighten the wire clamp screws.
Power port
2. Connect the terminal block to the Communicator.
3. Connect the Communicator to a power supply.
4. Turn on the power supply.
To Do Next
Connect the Communicator to the EtherNet/IP and EtherCAT network.
Check LED status, refer to Communicator LED
Page 16 of 61
Pin
1
2
3
Indicators.
Connect to Power
Description
12-30 VDC Power Connector
Ground (GND)
Functional Earth (FE)
SCM-1202-218 Version 1.0