Communicator Led Indicators - HMS Networks Anybus Communicator User Manual

Communicator LED Indicators

9.2. Communicator LED Indicators
This topic applies to different product variants for different networks.
NOTE
Before you can verify operation you must configure the Communicator.
Figure 40. Gateway status (A), Network connection (B)/(C) and Security switch (D)
Gateway status - LED A
Operation status
Off
Green, flashing
Green, solid
Red, flashing
Green/Red, flashing
Connection to client device
• LED B for product:
ABC3107 EtherNet/IP, ABC3128 Modbus TCP, ABC3113 PROFINET, and ABC3190 Common Ethernet
• LED C for product: ABC3100 PROFIBUS
Operation status PROFIBUS
Off No power/No data
exchange
Green, flashing Clear, data exchange
Green, one flash N/A
Green, solid Operate, data exchange
Red, solid N/A
Red, one flash Parameterization error
Red, two flash Configuration error
Red, three flash N/A
Red, flashing N/A
SCM-1202-218 Version 1.0
Description
No power
Startup phase
Operational
Invalid configuration
Power up self-test/Firmware update/Firmware recovery
EtherNet/IP
No power/No IP address
EtherNet/IP online, no
connections established
Running, one or more connections established
IP address conflict detected
N/A
N/A
One or more connections
timed out
® ™
Anybus Communicator - EtherNet/IP to EtherCAT MDevice
Modbus TCP PROFINET
No power/ No IP address No power/No connection
with IO controller
Modbus TCP online, no Used by engineering tools
messages received to identify the node on the
network
Connection with IO
controller established, IO
controller in STOP state or
IO data is inaccurate.
N/A
Station name not set
IP address not set
Expected Identification
differs from Real
Identification
Connection timeout N/A
Page 45 of 61