Table of Contents
Advertisement
1 5 F R O N T C A S T I N G S I N S T A L L A T I O N
Check that the two screws in the back of the fire front casting are in the inner threaded
1.
holes. If they are in the outer holes, relocate them.
See figure 35.
Locate the two screw heads through the keyhole
2.
slots at the inner sides of the surround. If the screw
heads do not project enough or project too far, the
screws can be adjusted. Lower the casting so that it
rests on the hearth. See figure 36.
Fit the "ash pan" cover below the front casting
3.
locating it as shown in figure 37.
4.
Figure 36. Fire front casting
location
Visually inspect the appliance. Clean off any marks incurred during installation.
1.
Advise the customer how to operate the appliance. Point out that lighting instruction
2.
details are on the metal plate attached at the bottom of the appliance (Leave the plate
visible in front of the bottom front cover as a reminder).
Explain to the customer that the appliance has a flame failure & spillage monitoring
3.
system. Point out the explanation of this system shown in the users instructions under
"Operating the fire". Advise that if the fire goes out for any reason, wait at least three
minutes before relighting. Stress that if the monitoring system repeatedly shuts off the fire,
the appliance should be switched off and a specialist should be consulted.
INSTALLER'S GUIDE
Figure 37. "Ash pan" cover location
1 6 F I N A L R E V I E W
Page 26
Figure 35. Casting screw
position.
Advertisement
Table of Contents
