Adorn Cast Front Installation; Adorn Safety Guard Fitting - Valor 922ECN Installation And Owner's Manual

Open front decorative vented gas fireplace

Table of Contents

12.

12.1

Carefully lift the casting. Place it against the fireplace front surface so that the retaining strip at the back of the casting

is above the two upper retaining brackets at the top of the convection box. Lower the casting making sure that the rear

retaining strip locates fully over the retaining brackets on the convection box (See figure 19).

12.3

Slide the front casting/surround sideways, if necessary, to align the bottom fixing holes with those in the convection

box. Fix the bottom of the casting/surround to the convection box with two screws (See figure 20).

Fig. 19 "Adorn" front casting top location

13.1

Locate the guard bottom wires over the brass ash lip. Hold the top springs down. Swing the guard back. Release the

springs so that they locate behind the canopy (See figures 22 and 23).

Figure 21 Fitting "Adorn" safety guard

#923 ADORN CAST FRONT INSTALLATION

Fig. 20 "Adorn" Front casting bottom fixing

Fig 22

14 of 19

Table of Contents

922ecp