Table of Contents
Advertisement
INSTALLATION
2.4.1 Installation Site and Environment
The following sites are not allowed installation:
a. Wall cavities;
b. On roofs not specifically deemed suitable;
c. Areas of access/egress;
d. Under stairways;
e. Under access walkways;
f.Sites where the freezing point is reached, like garages, carports or other
places;
g. Sites with humidity and condensation above 85%.
h. Places with plenty of salt.
i. Flooded areas.
j. Earthquake areas-additional security measures are needed here.
k. Places with altitude higher than 2,000 meters.
l. Place with explosive gases.
m. Place with direct sunlight.
n. Place with the ambient temperature extremely variable.
o. Places with highly flammable materials or gases.
p. Wet rooms
q. Places with potentially explosive gases.
r. Wall load bearing must exceed 180kg
NOTE:
a ~ e rules are set according to AS/NZS5139. If you install the system in Australia or
New Zealand, these rules must be followed. If the installing place is not in Australia or
New Zealand, and there are no such rules in local regulations, you do not need to
follow them.
2.4.2 Installation Tools
The following tools are required to install the equipment.
Wire
Cable
Screw Driver
Cutter
Clamp
Set
NOTE:
Use properly insulated tools to prevent accidental electric shock or short circuits. If
insulated tools are not available, cover the entire exposed metal surfaces of the
available tools, except their tips, with electrical tape.
T20 double offset ring
Percussion Drilling
spanner
07
08
2.4.2.1 Safety Gear
It is recommended to wear the following safety gear when dealing with the
battery pack
Insulated gloves
2.4.3 SMILE-B3 Installation
Step 1 Take out SMILE-B3 from the packaging box, as shown in Figure 2.6
NOTE: Please check whether the parts quantity is consistent with the parts list
after taking out the equipment.
Figure 2.7 Remove SMILE-B3 Upper Cover Plate
Step 2 Use the T20 double offset ring spanner to unscrew the screws, as shown in
Figure 2.7
NOTE: Please ensure that the main switch and branch switch on the side are
turned off before removing the upper cover plate to avoid short circuit.
Safety goggles
Figure 2.6 Remove SMILE-B3 Packaging
INSTALLATION
Safety shoes
Main Battery Breaker
Sub Battery Breaker
Advertisement
Table of Contents
