Table of Contents
Advertisement
INSTALLATION
NOTE:
It is not required to to fix the expansion bracket to the previous wall bracket, just
place them together for positioning; and then remove the expansion bracket
after tracing points.
Step 12 Drill holes at the position using a percussion drill (M12 drill, depth of holes:
70mm). After drilling, put 4 expansion bolts into the hole and take out the expansion
screws as shown in Figure 2.29
Figure 2.30 Fix the Wall Bracket
Step 13 Use a SW13 sleeve or other tools suitable for M8 flanges to lock the expansion
screws, and fix the wall bracket on the wall.
NOTE:
1. Please use leveling instrument to confirm that the hanging bracket is installed
on a horizontal line to ensure that the equipment will not deflect.
2. If the positioner is not removed, M4856-P can be not removed separately in
the future.
19
Figure 2.29 Holes for Fixing Bracket
20
Figure 2.31 Install the Battery
Step 14 Push the M4856-P into the wall bracket.
NOTE:
Please let someone support the battery after pushing in to prevent the battery
from falling until Step 15 is completed.
Figure 2.32 Lock the Battery to the Wall Bracket
Step 15 Use T20 screwdriver and T20 M5*10 screws to lock the battery to the wall
bracket. The torque is 2.8 Nm±10%
INSTALLATION
Advertisement
Table of Contents
