Table of Contents
Advertisement
INSTALLATION
Figure 2.24 Fix the Wall Bracket
Step 7 Use a SW13 sleeve or other tools suitable for M8 flanges to lock the
expansion screws, and fix the wall bracket on the wall.
NOTE:
1. Please use the leveling instrument to confirm the hanging bracket installed on
a horizontal line to ensure the equipment not to be deflected.
2. If the positioner is not removed, SMILE-B3 can not be removed separately.
Figure 2.25 Install the Battery
Step 8 Push the M4856-P into the wall bracket.
NOTE:
Please make sure someone else is holding the battery after it has been push into
the wall bracket to prevent the battery from falling until Step 9 is completed.
17
18
Figure 2.26 Fix the Battery to the Wall Bracket
Step 9 Use T20 screwdriver and T20 M5*10 screws to lock the battery to the wall
bracket. The torque is 2.8 Nm±10%。
Figure 2.27 Fix the Wall Bracket and the Expansion Bracket
Step 10 If you want to install more battery modules, please take out the wall bracket
and expansion bracket and fix them referring to Step 1- Step 3.
NOTE:
The expansion point of the wall bracket and expansion bracket must be the two
holes below (the holes for M4856-P expansion).
Figure 2.28 Positioning Between Wall Brackets
Step 11 Match the wall bracket with the wall bracket of the previous M4856-P.
INSTALLATION
Advertisement
Table of Contents
