Table of Contents
Advertisement
INSTALLATION
Figure 2.8 Stand Positioning
Step 3 Place the wall bracket on the wall where the system will be installed. And use
a marker to locate the bracket as shown in Figure 2.8.
NOTE: The hole position can be adjusted according to the site condition, but
it should be fixed at each of the four corners. And please use leveling
instrument to confirm that the hang-ing bracket is installed on a
horizontal line to ensure that the equipment will not deflect.
Step 4 Drill holes at the position using a percussion drill (M12 drill, depth of hole:
70mm). After drilling, put the 4 expansion bolts into the hole and take out the
expansion screws as shown in Figure 2.9.
Figure 2.9 Drill the Holes for Fixing and
Install Expansion Pipe
09
10
Step 5 Use a SW13 sleeve or other tools for M8 flange to lock the expansion screws
and fix the wall bracket, as shown in Figure 2.10.
Step 6 Install SMILE-B3 on the wall bracket, as shown in Figure 2.11.
Figure 2.10 Fix the Wall Bracket
Figure 2.11 Install SMILE-B3
INSTALLATION
Advertisement
Table of Contents
