Limitation Of Liability; System Installation - Alpha ESS SMILE-B3 Installation & Operation Manual

INSTALLATION
Table 5 SMILE-B3 WIFI (Yilian) Display
LED Status
Red
Green
Figure 2.2 SMILE-B3 Front View
1Grid and Backup: If It is necessary to use a bellows on the M25 single-hole water- proof
joint, M25 Pipe joint and Gum-elastic ring in the accessories can be used to replace the
compression head and clamping ring of this waterproof joint.(Only for AU)
2COM1 and COM2 both use M32 waterproof joint, which can respectively pass two
network cables and a CT harness.
3BAT: M32 double-hole waterproof joint. Both positive and negative power cables can
be installed from here if expansion is needed.
4 Battery Switch: Start the batteries.
Description
Normally on: normally communicate with EMS
Off: not connected to EMS
Flickers once in 30s : not connected to router
Flickers 3 times in 30s: not connected to server
Normally on: normal communication with server
Normally on after flickering: sending data to server
Main Battery Breaker
Sub Battery Breaker
Figure 2.3 SMILE-B3 Left View
Figure 2.4 SMILE-B3 Rear View
05 06

3. Limitation of Liability

AlphaESS shall not be liable directly or indirectly for any product damage or property
loss caused by any of the following conditions.
The product has been modified, the design modification or the change of parts without
the authorization of AlphaESS;
Non-AlphaESS technicians change, repair and serial number removing;
System design and installation fail to meet the standards and other relevant
requirements;
Fail to observe local safety regulations;
Transportation damage (including paint scratches caused by friction in packaging during
transportation). Once the container/package is unloaded and the damage is confirmed,
claims shall be put forward directly to the transport or insurance company;
Fail to comply with any/all user manuals, installation guide and maintenance rules;
Misfeasance or misuse of equipment;
Insufficient equipment ventilation;
Product maintenance procedures do not follow acceptable standards;
Force majeure (violent or stormy weather, thunder and lightning, overvoltage, fire, etc.);
Any damage caused by external factors

4. System Installation

This manual introduces the basic steps how to install and set up SMILE-B3.
Observe the specified minimum distance of adjacent objects;
Minimum distance guarantee;
Sufficient heat dissipation;
The upper cover of the energy storage system has enough space to open;
Sufficient room for maintenance.
Figure 2.5 Limit the Distance to an Adjacent Object
60cm
60cm
90cm
100cm
100cm
INSTALLATION