Table of Contents
Advertisement
INSTALLATION
ADL-3000 Connection (with CT and Meterplug):
Figure 2.47 ADL-3000 Connection (with CT and Meterplug)
NOTE:
In AC system the both two meters' addresses should be set, please refer to
2.4.5.5.1.
2.4.5.3 Electricity meter ACR10R (if optional)
AlphaESS
Grid Meter
PV Meter
RS485 PIN
RS485 PORT
RS485 PORT
3
6
7
8
7
8
R
J
4
5
R
J 4
5
Figure 2.48 ACR10R Connection
27
NOTE:
please pay attention to the
CT directions.
28
In AC system the both two meter addresses should be set, please refer to 2.4.5.5.2.
2.4.5.4 Mixed Installation of CT and Meter
A CT and a three-phase meter (ADL3000, ALD3000 with CT, ACR10R with CT) can be
installed in the same system, the CT and the meter shall be installed according to the
corresponding position, otherwise the system will run abnormally.
The initial setup is CT connection. If a meter is connected, after connecting, a relevant
configuration work shall be carried out by the installer on AlphaCloud, please refer to
5.1.2.
NOTE:
This function is released in SMILE-B3 EMS firmware version V1.00.33 or above.
In AC system and the mixed installation of CT and meter situation, the meter
address should be also set in the meter, please refer to 2.4.5.5.1 (ADL3000) and
2.4.5.5.2 (ACR10R).
2.4.5.5 Meter setting
2.4.5.5.1 ADL3000
Step 1 The initial interface of the meter
(normal working interface) is as shown
below:
Step 3 Click the "Enter" button to enter the
following interface, and press the up and
down arrow keys to enter the password
0001;
Step 5 Click the "Enter" button again to
enter the address interface:
INSTALLATION
Step 2 Click the "SET" button to enter the
password interface:
Step 4 Click the "Enter" button and the
password input is completed.
Step 6 Click the "Enter" button to enter the
following interface, press the up and down
arrow keys to set the meter address, the
Grid meter (DC, AC and Hybrid system)
address is set to 001, and the PV meter (AC
and Hybrid system) address is set to 002.
Advertisement
Table of Contents
